NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Collections About News Help Login
Back to Results
Formation of Oxides in the Interior of Friction Stir WeldsIn friction stir welding (FSWing) the actual solid state joining takes place between the faying surfaces which form the weld seam. Thus the seam trace is often investigated for clues when the strength of the weld is reduced. Aluminum and its alloys are known to form a native, protective oxide on the surface. If these native surface oxides are not sufficiently broken up during the FSW process, they are reported to remain in the FSW interior and weaken the bond strength. This type of weld defect has been referred to as a lazy "S", lazy "Z", joint line defect, kissing bond, or residual oxide defect. Usually these defects are mitigated by modification of the process parameters, such as increased tool rotation rate, which causes a finer breakup of the native oxide particles. This study proposes that there may be an alternative mechanism for formation of oxides found within the weld nugget. As the oxidation rate increases at elevated temperatures above 400ºC, it may be possible for enhanced oxidation to occur on the interior surfaces during the FSW process from entrained air entering the seam gap. Normally, FSWs of aluminum alloys are made without a purge gas and it is unknown how process parameters and initial fit up could affect a potential air path into the interior during the processing. In addition, variations in FSW parameters, such as the tool rotation, are known to have a strong influence on the FSW temperature which may affect the oxidation rate if internal surfaces are exposed to entrained air. A series of FSWs were made in 3 different thickness panels of AA2219 (0.95, 1.27 and 1.56 cm) at 2 different weld pitches. As the thickness of the panels increased, there was an increased tendency for a gap to form in advance of the weld tool. If sufficient air is able to enter the workpiece gap prior to consolidation, the weld temperature can increase the oxidation rate on the interior surfaces. These oxidation rates would also be accelerated in areas of localized liquation. Metallographs from the weld panels showed indications of liquation at the grain boundaries. In FSWs of thicker panels, these regions of liquation were found to be heavily oxidized. The quality of the FSWs was evaluated from tensile testing at room temperature. As the panel thickness increased, a slight decrease in tensile strength was observed which was attributed to the presence of oxides. No oxide formation was observed in the thinner workpieces, although there were indications of localized liquation at the grain boundaries. Results from this study will assist in a better understand of the mechanisms of oxide formation in FSW interiors and provide methodology for minimizing their occurrence.
Document ID
20160006969
Acquisition Source
Marshall Space Flight Center
Document Type
Conference Paper
Authors
Schneider, Judy (Alabama Univ. Huntsville, AL, United States)
Chen, Po (Jacobs Engineering and Science Services and Skills Augmentation Group (ESSSA) Huntsville, AL, United States)
Nunes, Arthur C., Jr. (NASA Marshall Space Flight Center Huntsville, AL, United States)
Date Acquired
June 3, 2016
Publication Date
May 17, 2016
Subject Category
Mechanical Engineering
Structural Mechanics
Report/Patent Number
M16-5253
Meeting Information
Meeting: International Friction Stir Welding Symposium
Location: Cambridge
Country: United Kingdom
Start Date: May 17, 2016
End Date: May 19, 2016
Sponsors: Welding Inst.
Distribution Limits
Public
Copyright
Public Use Permitted.

Related Records

There are no records associated with this record.
No Preview Available