Open Collections

Integrated multiphysics modeling, testing and optimization of friction stir welding of aluminum alloys

University of British Columbia

The main objective of this work is the development of a novel integrated multiphysics modeling, testing, and optimization of friction stir welding (FSW) for aluminum alloys, and thereby facilitating a better understating of processing-microstructure-properties relationships in this relatively new welding technique. To this end, in this paper-based dissertation, first we review various models and optimization methods used in the field of FSW. Next, based on the current state-of-the-art and a validated 3D thermal model for aluminum 6061 along with a Taguchi design of experiments approach, we make a proposition that hot welds (with maximum temperature during FSW) have the lowest mechanical properties as opposed to cold welds. Using further experimental studies we also propose that another determining parameter in the resulting mechanical properties of FSW welds is the material flow around the tool which in very cold weld conditions may cause low mechanical properties due to low mechanical bonding. Next, we develop and validate a novel two-dimensional Eulerian steady-state “integrated multiphysics” model of FSW of aluminum 6061 which did not exist earlier in the literature and can simultaneously predict temperature, shear strain rate, shear stress and strain fields over the entire workpiece. The model can additionally predict microstructural changes during and after FSW as well as residual stresses. In order to investigate the effect of different material constitutive equations on this integrated multiphysics model, we implement and compare most commonly used CFD (Computational Fluid Dynamics) and CSM (Computational Solid Mechanics) constitutive equations and show their similarities and differences. Using the same integrated multiphysics model, for the first time we also present a new semi-experimental approach to measure strain during FSW using visioplasticity. Finally, we perform a comprehensive experimental study (tensile testing, Electron Back Scatter Diffraction, Scanning Electron Microscopy, and micro-hardness testing) on FSW of aluminum 6061 samples in order to further validate the developed numerical model and optimize the welding process parameters (tool rotation speed, weld speed and axial force). The experimental study also prove the above mentioned preposition on a correlation among the processing-microstructure-mechanical properties during FSW, especially when comparing the UTS of samples from cold and hot weld conditions.

Text

2013-12-19

Attribution-NonCommercial-NoDerivatives 4.0 International

http://hdl.handle.net/2429/45659

Mechanical Engineering

University of British Columbia

UBCO

http://creativecommons.org/licenses/by-nc-nd/4.0/