Experimental study of K-feldspar dissolution rates as a function of chemical affinity at 150°C and pH 9

https://doi.org/10.1016/0016-7037(94)90190-2Get rights and content

Abstract

Steady state dissolution rates of a K-rich feldspar (K0.81Na0.15Ba0.03Al1.05Si2.96O8) were measured as a function of chemical affinity and aqueous Si and Al concentration in solutions containing 5 × 10−3 m total K using a titanium mixed flow reactor at a temperature of 150°C and pH of 9.0. All dissolution experiments exhibited stoichiometric dissolution with respect to Al and Si. The concentration of aqueous silica and Al ranged from 1 × 10−6to 5 × 10−4mol/kg and 4 × 10−7to 5 × 10−4mol/kg, respectively, corresponding to K-feldspar chemical affinities ranging from ~90 to ~5 kJ/mol. Logarithms of measured dissolution rates are an inverse linear function of aqueous aluminum concentration, but independent of aqueous silica concentration at all chemical affinities greater than ~20 kJ/mol. These rates become increasingly controlled by chemical affinity as equilibrium is approached. This variation of steady state dissolution rates is consistent with their control by the decomposition of silica rich/aluminum deficient surface precursor complex. Taking account of transition state theory and the identity of reactions to form this precursor complex, an equation was derived to describe the steady state dissolution rates over the full range of chemical affinity. A simplified but less general version of this equation, which can be used to describe the steady state rates (r) obtained in the present study can be expressed as r=k+1aAl(OH)+−aH+13 (1 − exp (− A3RT)) where k+ stands for a rate constant equal to 1.7 × 10−17 mol/cm2/s, aH+ and aAl(OH)4 designate the activities of H+ and Al(OH)4 , respectively, A refers to the chemical affinity of the overall reaction, R signifies the gas constant and T denotes the temperature in K. Corresponding experiments performed in a batch-type reactor illustrate the consistency between dissolution rates generated in open and closed systems.

References (50)

  • H.C Helgeson et al.

    Thermodynamic and kinetic constraints on reaction rates among minerals and aqueous solutions: II. Rate constants, effective surface area and the hydrolysis of feldspar

    Geochim. Cosmochim. Acta

    (1984)
  • R Hellmann

    The albite-water system: Part I. The kinetics of dissolution as a function of pH at 100, 200 and 300°C

    Geochim. Cosmochim. Acta

    (1994)
  • R Hellmann et al.

    The formation of leached layers on albite surfaces during dissolution under hydrothermal conditions

    Geochim. Cosmochim. Acta

    (1990)
  • J.W Johnson et al.

    SUPCRT92: A software package for calculating the standard molal properties of minerals, gases, aqueous species and reactions among them from 1 to 5000 bars and 0 to 1000°C

    Comp. Geosci.

    (1992)
  • K.G Knauss et al.

    Dependence of albite dissolution kinetics on pH and time at 25°C and 70°C

    Geochim. Cosmochim. Acta

    (1986)
  • M Lagache

    New data on the kinetics of the dissolution of alkali feldspars at 200°C in CO2 charged water

    Geochim. Cosmochim. Acta

    (1976)
  • W.M Murphy et al.

    Thermodynamic and kinetic constraints on reaction rates among minerals and aqueous solutions. III. Activated complexes and the pH-dependence of the rates of feldspar, pyroxene, wollastonite and olivine hydrolysis

    Geochim. Cosmochim. Acta

    (1987)
  • W.M Murphy et al.

    Surface exchange and the hydrolysis of feldspar

    Geochim. Cosmochim. Acta

    (1989)
  • E.H Oelkers et al.

    The effect of aluminum, pH and chemical affinity on the rates of aluminosilicate dissolution reactions

    Geochim. Cosmochim. Acta

    (1994)
  • N.M Rose

    Dissolution rates of prehnite, epidote and albite

    Geochim. Cosmochim. Acta

    (1991)
  • J Schott et al.

    Mechanism of pyroxene and amphibole weathering—I. Experimental studies of iron-free minerals

    Geochim. Cosmochim. Acta

    (1981)
  • J.H Scofield

    Hartree-Slater subshell photoionization cross sections at 1254 and 1487 eV

    J. Electron. Spectros. Related Phenom.

    (1976)
  • E Wieland et al.

    The coordination chemistry of weathering: III. A potential generalization on dissolution rates of minerals

    Geochim. Cosmochim. Acta

    (1988)
  • P Aagaard et al.

    Thermodynamic and kinetic constraints on the dissolution of feldspars

    GSA Abstr. Progr.

    (1977)
  • P Aagaard et al.

    Thermodynamic and kinetic constraints on reaction rates among minerals and aqueous solutions: I. Theoretical considerations

    Amer. J. Sci.

    (1982)
  • Cited by (202)

    • A comprehensive and internally consistent mineral dissolution rate database: Part I: Primary silicate minerals and glasses

      2022, Chemical Geology
      Citation Excerpt :

      Rates obtained in the presence of 1 atm pCO2 and/with added aqueous organic ligands are up to 1.5 log units faster than those measured at ambient pCO2 and in the absence of organic ligands (Busenberg and Clemency, 1976; Tan, 1980; Bevan and Savage, 1989). Moreover, experimental data from Swoboda-Colberg and Drever (1993) obtained at field and laboratory conditions and normalized to the geometric surface area, and data from Gautier et al. (1994) obtained at various close-to-equilibrium chemical affinities were also not considered for the regression. Experimental datasets that are not included for the kinetic fit are marked in circles in Fig. 5 and indicated in Table S1 in Appendix A.

    View all citing articles on Scopus
    View full text