This thesis describes direct measurements of equilibrium adsorption of ions in thin (< 100 nm) aqueous films. Adsorption in thin films is important because it is through adsorption that the stability of colloidal suspensions is frequently tuned. The vast majority of measurements of adsorption to date have been to a single interfaces, whereas the subject of this thesis is adsorption in a thin film between two interfaces. There are two isolated interfaces when particles in a suspension are far apart, but during the collision, a thin film forms between the particles, and the properties of the thin film determines the stability of the colloid. Thus, adsorption in the thin film determines the stability of the colloidal dispersion. There is a distinct gap in the scientific literature concerning adsorption in thin films mainly because there is no technique for measuring such adsorption. To fill this gap in knowledge, I first developed of a technique to directly measure adsorption in thin films, and then applied this technique to explore the behavior of co-ions near charged interfaces as a function of bulk solution composition and the thickness of the film.

The adsorption behavior of fluorescein, a di-anion, to negatively charged silica interfaces was studied in dilute electrolytes. The focus was on the effect of the electrostatic screening length, or Debye-length. The separation was measured using interference microscopy and the adsorption of fluorescein was measured using fluorescence microscopy. The Debye-length was altered by variation of the background salt (NaCl) concentration in dilute (<1 M) solution. The surface excess of adsorption for fluorescein was shown to depend on both the Debye-length and the separation distance between two interfaces. Increasing the Debye-length from 4 nm to 21 nm increased the plateau surface excess at large separations, and decreasing the separation lead to a monotonically decreasing surface excess. The surface excess varied over a range that scaled with the Debye-length. The results were compared to solution of the Poisson-Boltzmann model and good agreement was found between the model and the experiment.

The effect of background salt concentration on fluorescein adsorption was also studied in concentrated electrolytes (2.5 – 10 M) for various monovalent salts (LiCl, NaCl and CsCl). The results showed that the fitted electrostatic screening length showed an opposite trend to predictions from Poisson-Boltzmann, with the screening-length increasing with increasing salt concentration. That is, the Debye-length prediction was quantitatively incorrect and predicts the incorrect trend. For example, in 10 M LiCl where the Debye-length is 0.1 nm, and therefore colloidal chemists would traditionally predict that double-layer forces are negligible, my results show that the actual decay length is about 10 nm, which is about the same as in 10-3 M LiCl solution. The rate of increase of screening-length as a function of concentration was also an ion specific effect. In addition, the results show that there is an inversion of the surface charge in concentrated salt solution.

The original device on which all the above measurements were made had two limitations: (1) the maximum film thickness was 50 nm and (2) the film was asymmetric, which hampered calculation of the surface excess and increased the number of degrees of freedom in modeling of the adsorption. In the last part of my thesis, I describe development of a symmetric sample which (1) enables measurement of films up to 1 µm, (2) simplifies modeling of the optics by eliminating optical interference of the fluorescence excitation, and reduces the number of parameters when comparing to models.