Design and Low-Speed Validation of a Tailored Low-Loss Flow Straightening Device

TR Number
Date
2018-10-30
Journal Title
Journal ISSN
Volume Title
Publisher
Virginia Tech
Abstract

In many applications, non-uniform flows are undesirable and have a negative system impact. Non-uniform flows can arise in many ways such as in geometry changes and turns in piping/ducting, as well as with lip separation in certain aircraft engine inlets at high angle of attack. These non-uniformities can come with a variety of secondary flow patterns and thus highly three-dimensional flow. In a cylindrical coordinate system, these secondary (or in-plane) velocities have tangential and radial components. The tangential velocity is typically referred to as swirl and is the component of secondary flow that has the most system impact. These systems include industrial compressors, aircraft engines, and flow metering devices.

In industrial compressors and aircraft engines, swirl translates into off-design incidence angles on the blades. The off-design incidence can lead to blade stall, losses in performance, and loss in system operability. In flow metering, swirl can significantly reduce measurement accuracy, and is regulated in industries such as the oil and gas industry.

In the straightening of low-speed flows with approximately constant density and axial velocity, the velocity magnitude decreases and pressure increases along streamlines. This creates an unfavorable streamwise pressure gradient that inhibits the fluids ability to remain attached to the convex suction surface of the turning vane. This suction side separation causes the flow to under turn and exit at an angle not equal to the vane's trailing edge angle. The angle measured between the vane's trailing edge and the actual exiting flow angle is referred to as the deviation. Research on specific airfoil shaped turning vanes set up in linear cascade arrangements provides experimental data detailing the deviation measured at ranges of inlet flow conditions and vane spacing. These experimental data sets indicate that deviation angles were measured to be 10 degrees or higher in large vane spacing, high design flow turning arrangements. It is evident that in order to effectively straighten flow with turning vanes, the deviation must be predicted and accounted for in the design stage.

In this work, the design system of a new method of swirl mitigation is detailed and experimentally validated in a low-speed wind tunnel. The design system builds upon the fundamentals of the swirl-producing StreamVane design methods and is thus designated as the Inverse StreamVane. The complex arrangement of turning vanes in the StreamVane and Inverse StreamVane alike creates a spanwise variation of vane spacing. Calculated by a proximity approximation method, this local vane spacing, along with the local inlet flow conditions, become inputs to a derived function that predicts the local flow deviation. A root-finding method is utilized at each incremental vane section of each turning vane to converge on the design cambers that set the predicted local deviation angles equal to the local trailing edge angles.

Experimental and computational results validate the design method employed with the reduction of an experimentally measured 30 degree peak paired swirl profile to a 3 degree peak, 1.01 degree rms, swirl profile. Flow angularity and loss measurements detailed at 1/2 duct diameter downstream of the 1/6 duct diameter axial length of the device introduce the Inverse StreamVane as a very effective and efficient method of swirl mitigation.

Description
Keywords
StreamVane, Swirl, Distortion, Straightener
Citation
Collections