The effect of heat treatment on the properties of peek and its carbon fibre composites

Download

012825.pdf

Date

1990

Author

Kalay, Gürhan

Metadata

Show full item record

Item Usage Stats

53
views

0
downloads

URI

https://hdl.handle.net/11511/10932

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

The effect of silane coupling agents on the mechanical properties of polyhydroxybutyrate-valerate copolymer and hydroxyapatite composites Seydibeyoğlu, Mehmet Özgür; Bayramlı, Erdal; Department of Polymer Science and Technology (2001)
The effect of chemical admixtures and mineral additives on the properties of self-compacting mortars Sahmaran, M; Christianto, HA; Yaman, İsmail Özgür (2006-05-01) Mortar serves as the basis for the workability properties of self-compacting concrete (SCC) and these properties could be assessed by self-compacting mortars (SCM). In fact, assessing the properties of SCM is an integral part of SCC design. The objective of this study was to evaluate the effectiveness of various mineral additives and chemical admixtures in producing SCMs. For this purpose, four mineral additives (fly ash, brick powder, limestone powder, and kaolinite), three superplasticizers (SP), and two ...
The effect of metallurgical factors on the abrasive wear resistance of AISI 1040, 4340 and 5140 steels Dikmen, Deniz; Atala, Haluk; Department of Metallurgical Engineering (1988)
The effect of substrate and post-annealing temperature on the structural and optical properties of polycrystalline InSe thin films Parlak, Mehmet (Elsevier BV, 1998-06-08) X-ray diffraction, scanning electron microscopy, compositional analysis and transmission measurements are performed on InSe thin films grown by thermal evaporation at different substrate and annealing temperatures of 150-250 degrees C and 100-200 degrees C, respectively. An analysis of structural measurements indicates that there exist three phases of In-Se system like InSe, In2Se3 and In6Se7 in the same film at low-substrate temperature, but at high-substrate temperatures, In2Se3 phase was absent. The comp...
The effect of time on the form and stability of Pickering Emulsions Ayrancı Tansık, İnci (2013-08-18)

Citation Formats

G. Kalay, “The effect of heat treatment on the properties of peek and its carbon fibre composites,” Middle East Technical University, 1990.