Modelling of X-Band electromagnetic wave propagation

Download
2007
Pelgur, Ali
Calculation of electromagnetic wave propagation over irregular terrain is an important problem in many applications such as coverage calculations for radars or communication links. Many different approaches to this problem may be found in the literature. One of the most commonly used methods to solve electromagnetic boundary value problems is the Method of Moments (MoM). However, especially at high frequencies, the very large number of unknows required in the MoM formulation, limits the applicability of this method, since the memory requirement and the operation count increases by O(N2) and O(N3), respectively, where N is the number of the unknowns. Several approaches have been proposed in the literature to reduce the memory requirement and the operation count of the MoM. These approaches rely on the special structure of the impedance matrix generated by the MoM. The Conjugate Gradient (CG) method is a non stationary iterative technique that can be used to solve general asymmetric/non-Hermitian systems with an operational cost of O(N2) per iteration. Furthermore, the computational time can be improved by the Fast Fourier Transform (FFT) algorithm to perform the matrix vector multiplication that appear in any iterative technique. This approach has been successfully used in the literature to solve scattering from electrically large objects and it has been shown that the computational cost and memory requirement can be reduced to O(KNlogN) with K being the number of iterations. In this thesis, CG method accelerated with Fast Fourier Transform (CG FFT) method is applied to the problem of electromagnetic propagation over irregular terrain. Applications for electrically large rough terrain profiles are presented. The accuracy of the method is compared to the direct solution of the MoM, CG method and Free Space model with recoveries by Hata model or multiple knife-edge diffraction and reflection. The solution works on quasi-planar surfaces and profiles with small deviation like little breezy sea surface properly.

Suggestions

Estimation of deterministic and stochastic imu error parameters
Ünsal, Derya; Demirbaş, Kerim; Department of Electrical and Electronics Engineering (2012)
Inertial Measurement Units, the main component of a navigation system, are used in several systems today. IMU’s main components, gyroscopes and accelerometers, can be produced at a lower cost and higher quantity. Together with the decrease in the production cost of sensors it is observed that the performances of these sensors are getting worse. In order to improve the performance of an IMU, the error compensation algorithms came into question and several algorithms have been designed. Inertial sensors conta...
Implementation and performance evaluation of a three antenna direction finding system
Arslan, Ömer Çağrı; Tuncer, Temel Engin; Department of Electrical and Electronics Engineering (2009)
State of the art direction finding (DF) systems usually have several antennas in order to increase accuracy and robustness to certain factors. In this thesis, a three antenna DF system is built and evaluated. While more antennas give better DF performance, a three antenna system is useful for system simplicity and many of the problems in DF systems can be observed and evaluated easily. This system can be used for both azimuth and elevation direction of arrival (DOA) estimation. The system is composed of thr...
Design of a slotted waveguide array antenna and its feed system
Top, Can Barış; Hızal, Altunkan; Department of Electrical and Electronics Engineering (2006)
Slotted waveguide array (SWGA) antennas find application in systems which require planarity, low profile, high power handling capabilities such as radars. In this thesis, a planar, low sidelobe, phased array antenna, capable of electronically beam scanning in E-plane is designed, manufactured and measured. In the design, slot characterization is done with HFSS and by measurements, and mutual coupling between slots are calculated analytically. A MATLAB code is developed for the synthesis of the SWGA antenna....
Time domain scattering from single and multiple objects
Azizoğlu, Süha Alp; Koç, Seyit Sencer; Department of Electrical and Electronics Engineering (2008)
The importance of the T-matrix method is well-known when frequency domain scattering problems are of interest. With the relatively recent and wide-spread interest in time domain scattering problems, similar applications of the T-matrix method are expected to be useful in the time domain. In this thesis, the time domain spherical scalar wave functions are introduced, translational addition theorems for the time domain spherical scalar wave functions necessary for the solution of multiple scattering problems ...
Investigation of superdirective antenna arrays
Baktır, Yasemin; Koç, Seyit Sencer; Department of Electrical and Electronics Engineering (2009)
In some antenna applications, having high directivity while keeping the antenna dimensions small is desired, which can be obtained by use of superdirective arrays. Superdirective arrays have been popular in academic world since a superdirective array provides higher directivity than the uniformly excited antenna array of same length. In this thesis, superdirective arrays are investigated by making high precision numerical computations. Superdirective array element excitations, array factors and directivitie...
Citation Formats
A. Pelgur, “Modelling of X-Band electromagnetic wave propagation,” M.S. - Master of Science, Middle East Technical University, 2007.