Temper embrittlement behaviour of steel casting for welded structures

Download
082595.pdf
1999
Ertan, Aydın
Show full item record
89
views
0
downloads
https://hdl.handle.net/11511/1969
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Temper embrittlement behaviour of 32 CrMoV 1210 steel.
Onurlu, Sema; Department of Metallurgical Engineering (1983)
Creep behavior determination and remaining life estimation for centrifugally cast tubes made of Nb-stabilised 25/35 Cr Ni iron-based superalloy
Orhaner, Feyyaz Önder; Tekin, Erdoğan; Department of Metallurgical and Materials Engineering (1996)
Creep behaviour investigation of a thin spray-on liner
Güner, Doğukan; Öztürk, Hasan (Elsevier BV, 2018-08-01)
Thin spray-on liner (TSL) is a fast-setting multi component polymeric material applied on a rock surface with a thickness of 2-5 mm. TSLs are primarily used as an areal support element in a support system that also incorporates rock bolts. Different laboratory and field tests were performed to understand the support performance of the TSL for underground design. The research described in this paper presents laboratory studies of the tensile creep behaviour of a cement based TSL for the first time in the lit...
Creep modelling study of a surface support liner
Güner, Doğukan; Öztürk, Hasan (2018-06-24)
Surface supports are widely used in underground excavations. Since conventional surface support liners have inherently-brittle characteristics and require longer curing period, an alternative support system using polymer based surface support liner, thin spray-on liners (TSLs), has been observed to have a promising ductile and fast-curing potential for underground operations. TSLs can exhibit a good performance for highly-stressed, deep, rock bursting conditions as well when used together with rock bolts an...
Melt infiltration of ceramic preforms for functionally graded materials
Erdamar, Caner; Kalkanlı, Ali; Department of Metallurgical and Materials Engineering (2019)
The aim of this work was to produce ceramic-metal composite which shows combination of high hardness and high flexural strength by a combination of hard front layer and tough back layer by Functionally Graded Materials (FGM) process. Composition is the most important variable to obtain gradual changing green/bulk density and/or porosity which are the requirements of an FGM sample. Three different layers of FGM with gradual changing green density and/or porosity were pressed following by ball milling of diff...
Citation Formats
A. Ertan, “Temper embrittlement behaviour of steel casting for welded structures,” Middle East Technical University, 1999.
METU IIS - Integrated Information Service open@metu.edu.tr