Effects of processing on onion skin powder added extrudates

2020-09-01
Tonyali, Bade
Şensoy, İlkay
KARAKAYA, SİBEL
It is possible to enhance the functional properties of extruded products with the inclusion of fruit and vegetable by-products. Onion skin, a rich source of quercetin and fiber, is considered as waste in the industry and can be used as an alternative ingredient to improve the nutritional value of the extruded products. Three levels (3, 6, and 9%) of onion skin powder (OSP) were added to wheat flour and compared with control (0% OSP). The effect of the extrusion process on accessible quercetin, total phenolic content, and antioxidant activity of the samples were investigated. In addition, carbohydrate digestibility analyses were conducted for the products. Mass spectrometry (LC-MS/MS) results indicated that increasing the OSP level increased the quercetin content. The process caused the release of the entrapped quercetin from OSP, which was revealed by significantly higher quercetin levels for the extrudates. Some of the quercetin was lost during in vitro digestion process. Increasing the OSP level increased antioxidant activity and total phenolic contents of the samples. Total phenolic contents decreased significantly after the processing, yet antioxidant activities were not affected. The extruded products showed high amounts of rapidly available glucose (69.5 g/100 g). The OSP enhancement did not change the carbohydrate digestibility of products. The results indicated that the extrusion process could increase the level of accessible bioactive ingredients, and the level of functional compound addition can be optimized further.
JOURNAL OF FOOD SCIENCE AND TECHNOLOGY-MYSORE

Suggestions

The effect of onion skin powder addition on extrudate properties
Tonyali, B.; Şensoy, İlkay (2016-08-23)
The extrusion process is widely used in the industry to obtain different types of products such as breakfast cereals and snacks. The starch based extruded products which are nutritionally poor can be enriched by adding some fruit and vegetable based functional components. The functional components addition not only affects the nutritional value, but also the textural and physical structure of extrudates. In this study, the effects of addition of different levels of onion skin powder (3, 6 and 9%) to the whe...
Effect of extrusion on bioactive compounds found in artichoke leaf powder and on their in vitro bioaccessibilities
Güven, Özge; Şensoy, İlkay; Şenyuva, Hamide Z.; Department of Food Engineering (2016)
The functional properties of extruded products can be enhanced by addition of herbal ingredients. In this study, artichoke leaf powder (ALP) was added to extrudates, at 3%, 6% and 9% concentrations, to increase amount of bioactive nutrients. Aim of the study was to investigate the effect of extrusion on functional components and in vitro bioaccessibility of selected phenolic compounds. Extrusion feed flow rate was 55 ± 1 g/min, screw speed was 250 rpm and barrel temperature zones were set at 80°C, 90°C, 130...
Effect of some intense sweeteners on rheological, textural and sensory properties of chocolate
Yücekutlu, Mutlu; Öztop, Halil Mecit; Mert, Behiç; Department of Food Engineering (2015)
Development of a high-quality low-calorie chocolate needs the use of the most appropriate ingredients that could substitute sugar without negatively affecting several product properties. Although it is possible to formulate sugar-free or sugar-reduced chocolates with an acceptable sweetness level, these chocolates often show poorer sensory properties, especially undesirable mouthfeel, which could limit their consumption. In this study, low-sucrose chocolates sweetened with sucralose and stevia by using bulk...
Changes in functional properties and in vitro bioaccessibilities of beta-carotene and lutein after extrusion processing
Ortak, Melda; Caltinoglu, Cagla; Şensoy, İlkay; Karakaya, Sibel; Mert, Behiç (2017-10-01)
In this research, carrot pulp was added to traditional snack made from corn-grit. As the biological activity of carotenoids in the body depends on their bioaccessibility, change in carotenoid bioaccessibility during extrusion processing was investigated. In addition, phenolic content, antioxidant activity, beta-carotene and lutein contents were investigated before and after the extrusion process. Two different temperature profiles were used for extrusion process. In-vitro bioaccessibilities of beta-carotene...
EFFECTS OF SUCROSE POLYESTER COATING ON FRUIT-QUALITY OF APRICOTS (PRUNUS-ARMENAICA (L))
Şümnü, Servet Gülüm (Wiley, 1995-04-01)
Mature apricots were coated with different concentrations of a mixture containing sucrose polyesters (Semperfresh(TM) fruit coating) to determine the effect of that coating on shelf-life, post-storage life and quality of apricots. Respiration rates, weight loss, colour change, variations in soluble solids, ascorbic acid content, titratable acidity and pH of apricots were effectively reduced by both the 10 g litre(-1) and 15 g litre(-1) concentrations during ambient storage. After 10 days of cold storage bot...
Citation Formats
B. Tonyali, İ. Şensoy, and S. KARAKAYA, “Effects of processing on onion skin powder added extrudates,” JOURNAL OF FOOD SCIENCE AND TECHNOLOGY-MYSORE, pp. 3426–3435, 2020, Accessed: 00, 2020. [Online]. Available: https://hdl.handle.net/11511/34999.