Structural properties and room temperature mechanical properties of ultrafine eutectic Fe50Al50-nNbn alloys

Date

2017-10-06

Author

Yıldırım, Mehmet
Akdeniz, Mahmut Vedat
Mehrabov, Amdulla

Metadata

Show full item record

Item Usage Stats

26
views

0
downloads

URI

https://hdl.handle.net/11511/79369

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Structural and optical properties of thermally evaporated Ga-In-Se thin films IŞIK, MEHMET; Güllü, Hasan Hüseyin (2014-05-30) In this paper, structural and optical properties of Ga-In-Se (GIS) thin films deposited by thermal evaporation technique have been investigated. The effect of annealing was also studied for samples annealed at temperatures between 300 degrees C and 500 degrees C. X-ray diffraction, energy dispersive X-ray analysis and scanning electron microscopy have been used for structural characterization. It was reported that increase of annealing temperature results with better crystallization and chemical composition...
Structural and temperature-dependent optical properties of thermally evaporated CdS thin films IŞIK, MEHMET; Gullu, H. H.; Delice, S.; Parlak, Mehmet; Hasanlı, Nızamı (Elsevier BV, 2019-04-01) In this work, structural and temperature dependent optical properties of thermally evaporated CdS thin films were investigated. X-ray diffraction, energy dispersive spectroscopy and Raman spectroscopy experiments were carried out to characterize the thin films and obtain information about the crystal structure, atomic composition, surface morphology and vibrational modes. Temperature-dependent transmission measurements were performed in between 10 and 300 K and in the spectral range of 400-1050 nm. The anal...
Structural and optical properties of thermally evaporated Cu-Ga-S (CGS) thin films Gullu, H. H.; IŞIK, MEHMET; Hasanlı, Nızamı (2018-10-15) The structural and optical properties of thermally evaporated Cu-Ga-S (CGS) thin films were investigated by Xray diffraction (XRD), energy dispersive X-ray spectroscopy (EDS), atomic force microscopy (AFM) and optical transmittance measurements. The effect of annealing temperature on the results of applied techniques was also studied in the present paper. EDS results revealed that each of the elements, Cu, Ga and S are presented in the films and Cu and Ga concentration increases whereas S concentration decr...
Structural, electronic and mechanical properties of W1-xTcxB2 alloys Sürücü, Gökhan; Colakoglu, K.; Deligoz, E.; ÇİFTCİ, YASEMİN (2013-10-01) A detailed theoretical study of the structural, elastic and electronic properties of W1-xTcxB2 (x=0.1 similar to 0.9) alloys is carried out by using the plane-wave pseudopotential approach to the density-functional theory within the generalized gradient approximation (GGA). The most stable structure is found as W0.9Tc0.1B2 due to the lowest formation energy value and Band filling theory. Furthermore, the band structural and density of states (DOS) are computed for each composition x (0.1 similar to 0.9). Th...
Structural characteristics of thermally evaporated Cu0.5Ag0.5InSe2 thin films Gullu, H. H.; Parlak, Mehmet (2016-05-01) In this work, Cu0.5Ag0.5InSe2 (CAIS) thin film samples were prepared by thermal evaporation of Cu, Ag, InSe and Se evaporants sequentially on glass substrates. Following the deposition, annealing processes were applied at different temperatures. The as-grown and annealed CAIS samples were nearly stoichiometric in the detection limit of the compositional measurement. The x-ray diffraction (XRD) measurements revealed that they were in polycrystalline structure with a preferred orientation along the (112) dire...

Citation Formats

M. Yıldırım, M. V. Akdeniz, and A. Mehrabov, “Structural properties and room temperature mechanical properties of ultrafine eutectic Fe50Al50-nNbn alloys,” 2017, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/79369.