Selection of Optimum Riverbank Stabilization Facility

Date

2000-09-26

Author

Yanmaz, Ali Melih

Metadata

Show full item record

Item Usage Stats

34
views

0
downloads

URI

https://hdl.handle.net/11511/79599

Collections

Unverified, Conference / Seminar

Suggestions

OpenMETU
Core

Selection of Seismic Isolation Properties for Bridges in Near Fault Regions Dicleli, Murat (null; 2010-09-27)
Selection of Optimal Model Selection Criterion for Protein-Protein Interaction Networks Ağraz, Melih; Purutçuoğlu Gazi, Vilda (null; 2018-10-12)
Allocation of supplementary aeration stations in the Chicago waterway system for dissolved oxygen improvement Alp, Emre (2011-06-01) The Chicago Waterway System (CWS), used mainly for commercial and recreational navigation and for urban drainage, is a 122.8 km branching network of navigable waterways controlled by hydraulic structures. The CWS receives pollutant loads from 3 of the largest wastewater treatment plants in the world, nearly 240 gravity Combined Sewer Overflows (CSO), 3 CSO pumping stations, direct diversions from Lake Michigan, and eleven tributary streams or drainage areas. Even though treatment plant effluent concentratio...
Design of a special protection scheme and supplementary controls regarding HVDC back to back interconnection between Turkey and Georgia Tanıdır, Özgür; Güven, Ali Nezih; Tör, Osman Bülent; Department of Electrical and Electronics Engineering (2014) HVDC Back-to-Back interconnection between Turkey and Georgia is operational since November 2013. Previous feasibility analysis regarding to this project has shown that depending on the amount of power transfer between parties and loading conditions, there might be transmission bottlenecks and problems observed in Turkish Power System. In this respect, special protection coordination is required to maintain reliable and sustainable operation. In this thesis, design of a special protection scheme that coordin...
Selection of light source and implementation of data acquisition system of an optical experimental setup Reyhanioğlu, Erinç; Öke, Gülay; Department of Physics (2004) The construction of an optical experimental setup is the objective, to measure transmission coefficient of optical components used in plasma investigations. Thus, proper light source either with continuous or line radiation spectrum should be used. In addition, the detectors̕ output signal is recorded on a PC based data recorder after being digitized by an analog to digital converter card.

Citation Formats

A. M. Yanmaz, “Selection of Optimum Riverbank Stabilization Facility,” 2000, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/79599.