Determination of anatomical boundaries by ultrasound

Download
003682.pdf
1988
Dorken, Erkan
Show full item record
39
views
0
downloads
https://hdl.handle.net/11511/8428
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

DETERMINATION OF FOCAL FIELD-STRENGTH IN ULTRASOUND HYPERTHERMIA
KOYMEN, H; OZYAR, MS (1989-11-12)
DETERMINATION OF OPTIMUM INJECTED CURRENT PATTERNS IN ELECTRICAL-IMPEDANCE TOMOGRAPHY
KOKSAL, A; Eyüboğlu, Behçet Murat (IOP Publishing, 1995-08-01)
The problem of finding the optimum current under different constraints in electrical impedance tomography is cast into a non-linear optimization problem. Optimum currents are investigated for a two-dimensional cylindrical body with a concentric or an eccentric inhomogeneity under the constraints of constant dissipated power and constant total injected current. For a concentric inhomogeneity, it is shown that the opposite drive results in a better distinguishability than the cosine current pattern under the ...
Determination of Aggregate Morphological Indices through Photogrammetry
Öztürk, Hande Işık (2020-01-12)
Determination of contact angles of powders by capillaric dewatering of filter cakes
Eratak, Özlem Deniz; Hoşten, Çetin; Department of Mining Engineering (2005)
Solid-liquid contact angle is an important parameter in many particulate processes of the mineral, ceramic and chemical industries. In particular, modification of the contact angle through surface active agents plays a crucial role in froth flotation of minerals. In the case of flat solid surfaces, direct measurement of the contact angle is possible. However, such flat surfaces can not be obtained with finely divided solids typically encountered in flotation applications. Then, indirect methods based on pow...
Determination of coarse aggregate morphological indices and shape properties by 3d photogrammetry method
Rashidzade, Isfandiyar ; Öztürk, Hande Işık; Department of Civil Engineering (2021-4-8)
The morphological properties of the aggregatesplaya crucial role in the performance of the pavements. Therefore, thereexist various empirical methods and image-based approaches that directly or indirectly measure these properties. Image-based approaches are majorly classified as two-dimensional (2D) or three dimensional (3D). It has been reported in many studies that the 3D methods capture the overall aggregate morphological and shape properties more accurately than any 2D al...
Citation Formats
E. Dorken, “Determination of anatomical boundaries by ultrasound,” Middle East Technical University, 1988.
METU IIS - Integrated Information Service open@metu.edu.tr