Assessment of the effectiveness of a rockfall ditch through 3-D probabilistic rockfall simulations and automated image processing

Date

2021-03-01

Author

AKIN, MUTLUHAN
DİNÇER, İSMAİL
OK, ALİ ÖZGÜN
ORHAN, AHMET
AKIN, MÜGE
Topal, Tamer

Metadata

Show full item record

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Item Usage Stats

160
views

0
downloads

Rockfall ditches or catchment areas aim to collect falling blocks at the toe of a source zone by dissipating the energy of blocks in an excavated trench. The effectiveness of a rockfall ditch is simply expressed by its block catchment performance and can be evaluated by empirically using existing design charts as well as rockfall simulations. Although 2-dimensional (2-D) analysis has been executed to assess the catchment ditch effectiveness in engineering practice, 3-dimensional (3-D) rockfall models have not received enough attention so far. In this study, the effectiveness of a considerably long rockfall ditch to protect a settlement from falling rocks was assessed on the basis of 3-D rockfall analyses executed using high-resolution digital surface models. The rockfall ditch efficiency was found to be moderate to limited for various segments considering the percentage of blocks not trapped by the ditch. Moreover, the sensitivity of ditch efficiency to ditch depth was analyzed by automated image processing method as well. Additionally, a particular section of ditch alignment was fictitiously excavated or filled by synthetic Digital Surface Model (DSM) generation through image processing. 3-D rockfall modeling carried out using the DSMs with synthetically manipulated ditches points out that the effectiveness of a catchment ditch is highly depended upon ditch depth. Even a small volume of block accumulation inside the ditch definitely reduces the ditch performance resulting extended runout distances reaching to residential area. Finally, 3-D rockfall modeling is accepted to be an effective tool to rate the efficiency of existing rockfall ditches and synthetically generated ditches on DSMs (or DEMs) by means of automated image processing method may assist the control of current ditch dimension as well as new catchment ditch design.

URI

https://hdl.handle.net/11511/89810

Journal

ENGINEERING GEOLOGY

DOI

https://doi.org/10.1016/j.enggeo.2021.106001

Collections

Department of Geological Engineering, Article

Suggestions

OpenMETU
Core

Assessment of tunnel induced deformation field through 3-dimensional numerical models (Necatibey subway station, Ankara, Turkey) Aktürk, Özgür; Doyuran, Vedat; Department of Geological Engineering (2010) In heavily settled areas, deformations induced by the tunnel excavation may cause serious damage to nearby structures. In this study it is aimed to model ground deformations induced by main tunnels and connection tunnels excavations as well as groundwater drainage. Therefore, it is necessary to study effective means of controlling tunnel induced deformations. The main parameters affecting the failure and deformation state of the soil around a circular underground opening are the physical characteristics of ...
Assessment of cut slope stability in western Black Sea Region (Turkey) Özköse, Merve; Topal, Tamer; Department of Geological Engineering (2019) Cut slopes are intensely prone to weathering in the cause of excavation effects. Weathering effects can reduce strength of rocks and results in instabilities in the long run. By the reasons of rocks containing joints, fractures, faults, bedding planes and pore spaces, they are likely to be weathered because of wetting-drying cycles, climate changes, and chemical action of solutions absorbed. This study is mainly concerned with the slope stability analysis for sixteen permanent cut slopes that are composed o...
Probabilistic methods for estimating the seismic deformations of underground structures Soyman, Kadir Buğra; Gülerce, Zeynep; Department of Civil Engineering (2018) In seismic design of underground structures, simplified semi-deterministic methods based on the stiffness of the soil and the underground structure are used to estimate the seismic deformations. Generally, peak ground acceleration (PGA) value for different hazard levels are provided by the probabilistic seismic hazard assessment (PSHA) analysis, but a single (and deterministic) PGA value is employed in deformation calculations. The objective of this study is to propose a fully probabilistic framework for es...
Assessment of soil structure earthquake interaction induced soil liquefaction triggering Unutmaz, Berna; Çetin, Kemal Önder; Department of Civil Engineering (2009) Although there exist some consensus regarding seismic soil liquefaction assessment of free field soil sites, estimating the liquefaction triggering potential beneath building foundations still stays as a controversial and difficult issue. Assessing liquefaction triggering potential under building foundations requires the estimation of cyclic and static stress state of the soil medium. For the purpose of assessing the effects of the presence of a structure three-dimensional, finite difference-based total str...
The effect of group behavior on the pull-out capacity of soil nails in high plastic clay Akış, Ebru; Bakır, Bahadır Sadık; Department of Civil Engineering (2009) Soil nailing technique is widely used in stabilizing roadway and tunnel portal cut excavations. The key parameter in the design of soil nail systems is the pull-out capacity. The pull-out capacity of the soil nails can be estimated from the studies involving similar soil conditions or can be estimated from the empirical formulas. Field verification tests are performed before the construction stage in order to confirm the parameter chosen in the design of soil nailing system. It is reported in the literature...

Citation Formats

M. AKIN, İ. DİNÇER, A. Ö. OK, A. ORHAN, M. AKIN, and T. Topal, “Assessment of the effectiveness of a rockfall ditch through 3-D probabilistic rockfall simulations and automated image processing,” ENGINEERING GEOLOGY, pp. 0–0, 2021, Accessed: 00, 2021. [Online]. Available: https://hdl.handle.net/11511/89810.