Evaluation of thermoplastic filaments to construct a disposable 3D printed platform for atomic absorption spectrometry
Nenhuma Miniatura disponível
Data
2021-01-01
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
Additive manufacturing (AM) is gaining considerable interest due to the inherent capacity of fast and low-cost prototyping of customized devices and parts. In this work, seventeen commercial thermoplastic polymer filaments (PLA, TPU, and ABS) and one PLA pellet for fused deposition modeling (FDM) were characterized and evaluated to develop a disposable sample holder to be used as a solid sampling platform in graphite furnace atomic absorption spectroscopy (GFAAS). For GFAAS application, the selection of polymer filaments took into account no or minimal mass residue, decomposition profile, the lowest thermal decomposition temperatures, and colorless filament (preferably). These conditions are essential for the rapid and complete elimination of polymeric matrix without generating residues inside the graphite tube atomizer and lower analytical blanks. Thus, the filaments and pellets were characterized by thermogravimetry, derivative thermogravimetry, differential thermal analysis, differential scanning calorimetry, Fourier-transform infrared spectroscopy and scanning electron microscopy/energy-dispersive X-ray spectroscopy. It is desirable that the sample holder can be entirely decomposed at the lowest possible temperature. The PLA pellet material was chosen because it presented glass transition 71.7 ∘C, melting temperature at 182.7 ∘C, and showed single decomposition step in the 245–325 ∘C range (with peak temperature at 304.4 ∘C), without generating mass residue. The printed sample holder was tested in a commercial spectrometer. As “proof-of-concept, the calibration curve for cobalt (0–9.0 ng) was built up with a correlation coefficient of 0.9987. The RSD was < 10%, and the quantification limit was 1.18 ng. Recoveries of Co added to water samples varied from 96–102%.
Descrição
Palavras-chave
3D printing, GFAAS, Sampler platforms, Structural characterization, Thermal stability, Thermoplastic filaments
Como citar
Journal of Thermal Analysis and Calorimetry.