Characterization of the porosity developed in a new titania-alumina catalyst support prepared by the sol gel route
Nenhuma Miniatura disponível
Data
2003-06-01
Autores
Kaneko, E. Y.
Pulcinelli, Sandra Helena [UNESP]
Santilli, Celso Valentim [UNESP]
Craievich, A. F.
Chiaro, SSX
Título da Revista
ISSN da Revista
Título de Volume
Editor
Blackwell Munksgaard
Resumo
Titanium oxide (TiO2) is a good candidate for support of hydrotreating catalysts but has the disadvantage of presenting a low surface area and a poor thermal stability when compared with Al2O3. A mixed TiO2-Al2O3 support was proposed as an alternative that is expected to be free from these drawbacks. The variation during firing of the nanoporous texture of supports composed of TiO2-Al2O3, TiO2 and Al2O3 was studied by small angle X-ray scattering (SAXS). The supports were prepared by the sol-gel route using Ti and Al isopropoxides. We have particularly analyzed the effects of acid and basic hydrolysis on the nanostructural features of catalyst supports fired at different temperatures. The nanopore radius distribution functions were determined from SAXS results assuming a simple model of spherical nanopores embedded in a homogeneous solid matrix. The modal pore radius in both pure TiO2 and pure Al2O3 supports grows from 1.3 to 2.2 nm as the firing temperature increases from 673 to 973 K. on the other hand, the modal pore radius in the mixed TiO2-Al2O3 support remains below 1.2 nm over the same range of firing temperatures. These results demonstrate the good thermal stability of the nanoporous texture of mixed TiO2-Al2O3 supports.
Descrição
Palavras-chave
catalyst supports, sol-gel, nanoporous texture
Como citar
Journal of Applied Crystallography. Copenhagen: Blackwell Munksgaard, v. 36, p. 469-472, 2003.