Deformation behaviour of metal-metal laminates: a fem study

Download
068707.pdf
1997
Ercan, Ozan
Show full item record
35
views
0
downloads
https://hdl.handle.net/11511/10698
Graduate School of Natural and Applied Sciences, Thesis

Suggestions

Deformation characteristics of simply supported R.C. beams under sustained load.
Fraywat, Shurki; Department of Civil Engineering (1966)
Deformation and failure analysis of laminated composites by isogeometric elements formulation
Aydın, Cansın Bade; Darendeliler, Haluk; Department of Mechanical Engineering (2020)
The finite element method (FEM) is the most widely used technique for solution ofengineering problems. In classical finite element analysis (FEA) procedure, the exactgeometry generated in computer aided design software is regenerated to have an anal-ysis suitable model, then this model is used for solution. Isogeometric analysis (IGA)is a computational approach which eliminates the modification phase of the actualgeometry in FEA. Instead, IGA employs the same mathematical model which definesthe geometry in ...
Deformation modulus of heavily jointed-sheared and blocky greywackes by pressuremeter tests: Numerical, experimental and empirical assessments
IŞIK, Nihat Sinan; ULUSAY, REŞAT; Doyuran, Vedat (2008-10-17)
Deformability of rock masses influencing their behavior is an important geomechanical property for the design of rock structures. Due to the difficulties in determining the deformability of jointed rock masses at the laboratory-scale, various in-situ test methods such as pressuremeter, dilatometer, plate loading tests etc. have been developed. Although these techniques are currently the best and direct methods, they are time-consuming and expensive, and present operational difficulties. In addition, the inf...
DEFORMATION ANALYSIS OF TWO LAYER COMPOSITE TUBES UNDER CYCLIC LOADING OF EXTERNAL PRESSURE
Eraslan, Ahmet Nedim (2016-01-01)
The stress response of axially constrained two-layer composite tubes under cyclic loading of external pressure is investigated in this study. Elastic and elastoplastic stress states for the tube assemblies are examined by developing a mathematical model based on Tresca's yield criterion, its associated ow rule, and linear strain hardening. Using this model, the composite tubes with different dimensions are analyzed under one cycle of loading, unloading, and reloading of external pressure. It is observed tha...
Deformation patterning driven by rate dependent non-convex strain gradient plasticity
Yalçınkaya, Tuncay; Geers, M.G.D. (2011-01-01)
A rate dependent strain gradient plasticity framework for the description of plastic slip patterning in a system with non-convex energetic hardening is presented. Both the displacement and the plastic slip fields are considered as primary variables. These fields are determined on a global level by solving simultaneously the linear momentum balance and the slip evolution equation which is postulated in a thermodynamically consistent manner. The slip law differs from classical ones in the sense that it includ...
Citation Formats
O. Ercan, “ Deformation behaviour of metal-metal laminates: a fem study,” Middle East Technical University, 1997.
METU IIS - Integrated Information Service open@metu.edu.tr