A comparative study on the nonlinear behavior of chevron and suspended zipper braced steel frames

Download

index.pdf

Date

2010

Author

Özçelik, Ahmet Yiğit

Metadata

Show full item record

Item Usage Stats

168
views

61
downloads

Chevron braced steel frames require large beams to redistribute the unbalanced vertical forces exerted on the beams after brace buckling. A new frame configuration similar to chevron brace was proposed in literature, where zipper columns were attached between mid-spans of the beams from second to top story. During severe ground motion, the unbalanced vertical forces caused by buckling of lower story braces are in this case redistributed to the upper story braces by these zipper columns. Consequently, all story braces buckle successively from first to top story brace instead of concentration of inelastic action in one story. This system has been improved recently by adding an elastic hat truss between the top two stories to prevent formation of a full zipper mechanism and to prevent collapse. Two-phase numerical study is undertaken in this study to evaluate the response of chevron and suspended zipper braced frames, where the objective of the first phase is to observe the change in the performance of the configurations for different sets of initial imperfection and rotational spring stiffness values. Rotational springs are added at the end nodes of the braces to represent the effects of gusset plates and initial imperfection is assigned to the mid-length of the braces to achieve proper buckling behavior. The objective of the second phase is to compare the response of chevron and suspended zipper brace frames. For this purpose, three, nine and twenty-story buildings are designed for both brace configurations. The designed buildings are analyzed under static and dynamic loadings.

Subject Keywords

Civil engineering.

URI

http://etd.lib.metu.edu.tr/upload/2/12611783/index.pdf
https://hdl.handle.net/11511/19493

Collections

Graduate School of Natural and Applied Sciences, Thesis

Suggestions

OpenMETU
Core

A numerical study on response factors for steel wall-frame systems Arslan, Hakan; Topkaya, Cem; Department of Civil Engineering (2009) A numerical study has been undertaken to evaluate the response of dual systems which consist of steel plate shear walls and moment resisting frames. The primary objective of the study was to investigate the influence of elastic base shear distribution between the wall and the frame on the global system response. A total of 10 walls and 30 wall-frame systems, ranging from 3 to 15 stories, were selected for numerical assessment. These systems represent cases in which the elastic base shear resisted by the fra...
The effect of shape memory alloys on the ductility of exterior reinforced concrete beam-column joints using the damage plasticity model Halahla, Abdulsamee M.; Abu Tahnat, Yazan B.; Almasri, Amin H.; Voyiadjis, George Z. (Elsevier BV, 2019-12-01) Using shape memory alloys (SMA) bars can significantly enhance the ductility of exterior reinforced concrete joints, where they can replace the conventional steel reinforcement. This research focuses on studying the effect of using SMA on the ductility capacity of exterior reinforced concrete beam-column joints at different column axial load levels. Finite element analysis was carried out and compared with the experimental results from the literature for verification purposes, and both were compared with th...
A numerical study on linear bifurcation web buckling of steel I-beams in the sidesway mode Topkaya, Cem (Elsevier BV, 2006-06-01) Sidesway web buckling is a limit state that needs to be considered during the design of steel I-beams subjected to transverse concentrated loads. Sidesway web buckling capacity equations presented by design codes offer estimates which are conservative to varying degrees. In this paper, the sidesway web buckling equations used by the AISC-LRFD specification are revisited. A parametric study based on finite element analysis has been conducted to identify the parameters that influence the web buckling of simpl...
A numerical study on special truss moment frames Ölmez, Harun Deniz; Topkaya, Cem; Department of Civil Engineering (2009) A three-phase numerical study was undertaken to address some design issues related with special truss moment frames (STMFs). In the first phase, the design approaches for distribution of shear strength among stories were examined. Multistory STMFs sized based on elastic and inelastic behavior were evaluated from a performance point of view. A set of time history analysis was conducted to investigate performance parameters such as the interstory drift ratio and the plastic rotation at chord member ends. The ...
A study on the effect of pipe - soil relative stiffness on the behaviour of buried flexible pipes Bircan, Mehmet; Özkan, M. Yener; Department of Civil Engineering (2010) In this study, the effect of pipe-soil relative stiffness on the behaviour of buried flexible pipes was investigated considering the pipe size, material type, stiffness, pipe-soil and natural soil-backfill interfaces and geometry of the trench using the finite element method. For this purpose, a parametric study was conducted to examine the effect of different variables on the resulting earth loads and deformations imposed on the buried pipes. Various types of trench pipe-soil cases were analysed for a cert...

Citation Formats

A. Y. Özçelik, “A comparative study on the nonlinear behavior of chevron and suspended zipper braced steel frames,” M.S. - Master of Science, Middle East Technical University, 2010.