Direct analysis of aluminum alloys by CSigma laser-induced breakdown spectroscopy
Fecha
2018Versión
Acceso abierto / Sarbide irekia
Tipo
Artículo / Artikulua
Versión
Versión publicada / Argitaratu den bertsioa
Impacto
|
10.1016/j.aca.2018.01.019
Resumen
We report the application of CSigma laser-induced breakdown spectroscopy (Cσ-LIBS) to quantitative analysis of aluminum alloys without sample preparation. Cσ-LIBS simplifies strongly the conventional calibration procedure of LIBS, replacing it with a characterization stage performed from the spectrum of a single standard sample. The aim of this work has been to provide a complete evaluation of th ...
[++]
We report the application of CSigma laser-induced breakdown spectroscopy (Cσ-LIBS) to quantitative analysis of aluminum alloys without sample preparation. Cσ-LIBS simplifies strongly the conventional calibration procedure of LIBS, replacing it with a characterization stage performed from the spectrum of a single standard sample. The aim of this work has been to provide a complete evaluation of the use of Cσ-LIBS for direct analysis by obtaining its figures of merit, including precision and limits of detection. Ten elements (Si, Fe, Cu, Mn, Mg, Cr, Ni, Zn, Ti and Ca) are determined in a set of six certified samples with a wide range of concentrations, from percent down to μg/g levels. The average precision is 8.0% for concentrations higher than 0.1 wt% and 13% for concentrations between 0.1 wt% and 0.01 wt%. The limits of detection are in the range 1.4–9.7 μg/g. [--]
Materias
Laser-induced breakdown spectroscopy,
LIBS,
CSigma LIBS,
Quantitative analysis,
Standardless analysis,
Aluminum alloys
Editor
Elsevier
Publicado en
Analytica Chimica Acta, 2018, 1009, 12-19
Departamento
Universidad Pública de Navarra. Departamento de Ciencias /
Nafarroako Unibertsitate Publikoa. Zientziak Saila /
Universidad Pública de Navarra/Nafarroako Unibertsitate Publikoa. Institute for Advanced Materials and Mathematics - INAMAT2
Versión del editor
Entidades Financiadoras
This work has been supported by the project FIS2014-54285-P of the Spanish Ministerio de Economía y Competitividad.